Christie J series 2.4kW Einstellungsanleitung Seite 21

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 60
  • Inhaltsverzeichnis
  • FEHLERBEHEBUNG
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 20
Section 2: Installation and Setup
J Series 2.0, 2.4, and 3.0 kW Setup Guide 2-11
020-100751-01 Rev. 1 (10-2011)
2.2.5 Projector Communications
Status LEDs
Looking from the back of the projector, the LEDs represent, from left to right; Lamp, Comm, Status, and
Shutter. The LEDs will display the colors as shown below:
Status LEDs # LED State
Lamp 1 Off - lamp off
Yellow- Lamp time has expired and lamp should be
replaced
Green - Lamp is on and operating correctly
Flashing Red - Lamp has malfunctioned
Flashing Yellow - Lamp door is open
Comm 2 Flashing Green - Projector communication in progress
Status 3 Off - AC power is off
Yellow- AC is present but projector is in standby
Green -Projector is powered up and operating normally
Flashing Red - Error has occurred. Details are displayed
on the status display
Shutter 4 Green - Shutter is open
Yellow - Shutter is closed
NOTE: A condition occurs on the first power on after a software upgrade, and is indicated by all the following:
The Status LEDs are cycling green
The LCD displays the warning "Image Processor Upgrading"
The LED on the Image Processor card flashes green
The Web page shows a warning that the Image processor card is upgrading.
When this occurs, the projector should not be AC power cycled and the Image Processor card should not be removed.
Seitenansicht 20
1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 59 60

Kommentare zu diesen Handbüchern

Keine Kommentare