Christie CP2215 Bedienerhandbuch PDF herunterladen (Seite 13)

Installation and Setup

CP2215 Quick Start Guide 9

020-101295-01 Rev. 2 (05-2014)

7. Loosen the cathode screw (D) with the 5 mm hex key attached to the lamp door.

8. Install the lamp:

a. Remove the tape from the ends of the protective case.

b. Remove the plastic packing material from the lamp.

c. Remove the cathode nut from the lamp before removing it from the case.

d. Hold the anode end of the new lamp in your left hand and angle it up through the hole in

the back of the reflector assembly.

e. Insert your right index and middle finger through the back of the reflector and guide the

lamp onto the cathode clamp. Be careful not to hit the lamp against the reflector.

Anode Terminal

Anode Wire

Reflector

Cathode Screw

Cathode Nut

Cathode Clamp

Handle the lamp by the cathode/anode end shafts only, never the glass.

DO NOT over-tighten. DO NOT stress the glass in any way. Check leads.

Make sure the anode (+) lead between the lamp and igniter is well away

from any projector metal, such as the reflector or fire wall. Failure to

comply could result in minor or moderate injury.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 37 38

Keine Kommentare

Christie CP2215 Bedienerhandbuch Seite 13