
RPMS-D100U/UF,
CS50-D100U, CS70-D100U/UF
3 of 6
Lamp Replacement
- Instruction Sheet -
HOT SWAP ALTERNATIVE: If you choose to replace a lamp without disrupting the current
presentation, it is recommended that you switch to the Single Lamp mode for the lamp you are
not going to replace. Then proceed with Step 2.
2. OPEN LAMP COMPARTMENT: Loosen the two captive screws on the lamp door you want to
open. Swing the door open. (NOTE: Each lamp door is spring-loaded and needs to be held
open during lamp replacement.
Figure 1.
OTE: To access the lamp in a CS7
remove the projector access panel - 7
screws.
Remove 7 screws.
OTE: To access the lamp in a CS5
remove the lamp access panel – 4 screws.
Kommentare zu diesen Handbüchern