Christie CP2000-X Einstellungsanleitung PDF herunterladen (Seite 20)

2-8 CP2000 Setup Guide

020-100070-01 Rev. 1 (10/08)

Section 2: Installation and Setup

In the lamp cooling compartment:

• With the lamp door removed (Figure 2-10), turn the small knob and swing open the lamp cooling

compartment door.

• Route the NEGATIVE (-) BLACK lamp lead through the hole in the cooling compartment floor.

The igniter wires from terminal "5" and the PCB are also routed here (Figure 2-11).

• A universal connector nut should be pre-installed on the cathode-end lamp post. Regardless of model

or lamp size, this nut is 1.658" in overall length (Figure 2-12).

NOTE: The universal nut shown accommodates all models. Do not install a shorter nut.

FIGURE 2-10 ACCESSING CATHODE END

FIGURE 2-11 FEED BLACK LEAD

INTO COMPARTMENT

FIGURE 2-12 CONNECTOR NUT

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 63 64

Keine Kommentare

Christie CP2000-X Einstellungsanleitung Seite 20